Turning

Subject:
Re: How will you remove the pulleys? Nova 3000

John lucas
I had that lathe. Sometimes it's very hard to get the pulleys off because of a burr created by the set screw. Take a drill bit that just barely fits in the set screw hole. Drill very lightly. That should get rid of the burr and make removing the pulley easy.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081