Hand Tools

Subject:
A new infill *PIC*

CJ in MPLS
I just finished (almost) a new infill miter plane based on the A11 design.

The blade is bedded at 20 degrees. Both the blade and lever cap are from St. James Bay Tool Co and I've had them for at least 10 years I think. The infill is bocote and while it looks great, that is some gooey stuff.

I am still considering whether to send it out for grinding or to do more flattening on the table saw extension. Both ways are expensive ($ v. soreness).

CJ

Messages In This Thread

A new infill *PIC*
Re: A new infill
Re: A new infill
Re: A new infill
Re: A new infill
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081