Hand Tools
Subject:
Marples catalog...Response To:
Factory ground *PIC* () David Weaver
i tracked that picture down to an 1862 marples catalog. The mortise chisels that I have are likely from 1822 - 1850.
more from this maker:
https://www.tooltique.co.uk/shop/special-vintage-i-h-sorby-of-sheffield-%C2%BD-wide-mortice-chisel/
https://www.tooltique.co.uk/shop/vintage-i-h-sorby-3-16-cast-steel-mortice-chisel-sharpened-honed/
https://www.jimbodetools.com/products/9-16-inch-i-h-sorby-pig-sticker-mortise-chisel-87074
I see none with a short flat bevel, and none without the characteristic curve at the top of the primary bevel unless they are very short.
Messages In This Thread
- Sharpening and buffing progression pictures *PIC*
- Re: Sharpening and buffing progression pictures
- Re: Sharpening and buffing progression pictures
- Thinking about establishing the Unicorn profile
- David & Winston
- Scratches from various compounds *PIC*
- these results will require some study
- The white stuff is...
- Re: The white stuff is...
- various compounds - difficult to judge
- Scratches from more compounds; buff vs stick *PIC*
- Re: Scratches from more compounds; buff vs stick
- great experiments
- Other Compounds
- great experiments
- The white stuff is...
- Calcined alumina *PIC*
- Profile pictures *PIC*
- Capturing the Unicorn Profile
- Angle near the edge *PIC*
- Thoughts on the data
- Angle near the edge *PIC*
- Comparative Profile Pictures
- Separate on the IH sorby chisels..
- Re: Sharpening and buffing progression pictures
- Re: Sharpening and buffing progression pictures
