Turning Archive 2008

Subject:
Going with the grain...
Response To:
Re: Rottenstone ()

Steven Kubien
>I understand that in typical furniture situations you go- with the grain with either pumice or r-stone but what about with turnings? I realize that wood is wood but since a lot of the finishes we use are applied on the lathe with the piece spinning I wonder if it is appropriate to use these on a spinning lathe as well.

What say you?

Steve Kubien

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081