Turning Archive

Subject:
Re: HAZARD with CBN wheels

Reed Gray
I don't remember if I have pictures or not in my CBN wheel article on my web site, but I had some of 'fuzzy' tools. Laying the gouges next to the grinder where metal dust was accumulating, when I picked them up, some had full beards, like mine.... Could be a number of reasons. Looks like there is still a lot to learn about dealing with grinder dust. I never considered magnets to be a good solution for the CBN wheel dust....

robo hippy

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081