Turning Archive

Subject:
Re: Jet 1642 Troubleshooting

mikeee12345
If it ends up being a bad sensor you should be able to read the manufacturer and model number on the sensor and find one on Ebay or Amazon for less money. Re-aligning the target on the spindle is most likely the issue that is the problem if not it could be the sensor or a loose wire.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081