Turning Archive

Subject:
Re: Jet 1642 Troubleshooting
Response To:
Jet 1642 Troubleshooting ()

jake niedling
I have never had an RPM readout, so not having it doesn't seem like much of an issue. My PM 3520A was not equipped with one. I adjust the the speed depending on all the variables that we all run into ( diameter, balance, cut, vibration, type of wood, etc.). Sounds like Doc has some good advice, as he always does. Good luck.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081