Turning Archive

Subject:
John is on the right path if the tool.....
Response To:
Re: bowl turning ()

JamieDonaldson
... is a cupped tip Hunter, as there is no such animal as a carbide "bowl gouge." Never present that type of tool with the cutter horizontal to the grain center line, but angled about 45 degrees and pull cuts only, starting in the bottom center of the bowl blank.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081