Turning Archive

Subject:
Re: They use metal lathes for most of the lecture

John C Lucas
The holder for my boring bar has a 3/4" hole so.i just stuck a rod.in that a d then addes.a.bolt and nut that acts as an outboard support for the loose end of the rod. I can adjust it up and down a little ad since its attached to the cross feed.table i can move.it up and down the bed.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081