Turning Archive

Subject:
Foredom stand *PIC*

john lucas
I haven't had much time in the shop since I'm taking my stepson to radiation everyday so I planned a project that I could do a little each morning and evening. I needed a stand for my rotary carving tools. I scrounged up a bunch of scrap 2x4 and 2x6 pieces. I made the column in 3 parts due to the wood I had. Glued up 2 pieces each for the bottom and middle section. turned the top out of one piece. The base was some short 2x6 pieces I had that were cut offs. It will have wheels installed after the paint dries. You can see the Foredom's laying on the back of the lathe. I'll put some hangers on it and hang those along with a Dremel with it's flex shaft.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081