Turning Archive

Subject:
Re: Carba-tec Threadmaster

Ken Vaughan

3/4 by 16 and 3/4 by 10 are good threads for the inside of the bushings.

They are easy to get as all thread rod, and fittings to chuck/faceplate threads are readily available (if not already in hand).

X-Y vise is a good adjustable mounting base

This jig does not need to be precise on centerline. Close or even sloppy close works fine.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081