Turning Archive

Subject:
Re: Repairing Robust Tool Rest

Keith Newton
Dennis, is the rod smooth on the bonded side? If so, that is the problem. NO epoxy likes to stick to really smooth surfaces, so you need to give it some tooth to grab onto.

Use your coarsest grit grinder and run down that side, then work in good to make sure it gets down in the scratch good.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081