Hand Tools Archive

Subject:
Demonstrating the Knew Concepts fretsaw

Derek Cohen (in Perth, Australia)
While working on the current build (I will post this later), I took a couple of minutes to make a very short video using a Knew Concepts fretsaw to remove the waste from pins. The purpose is to demonstrate how to efficient this process is, as compared with chopping the waste out. Note that the wood is 20mm thick Hard Maple (it is indeed very hard wood!). These are mitred through dovetails for the carcase of a side table with drawers.

https://www.youtube.com/watch?v=M6O4rY_0zQs&feature=youtu.be

Regards from Perth

Derek

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081