Hand Tools Archive

Subject:
Re: Wire wheel question
Response To:
Wire wheel question ()

david weaver
Do you have a lathe? You can make a bearing or sleeve if you do (presumably the width is a problem for stock bearings?)

Corian is a good bearing material - you can turn it on a lathe. Even if you don't have a lathe, I'll bet you could rig up some kind of friction fit setup to do it on a drill press.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081