Hand Tools Archive

Subject:
Screw it to a waste block on faceplate of lathe.
Response To:
Re: cutting holes in uhmw plastic ()

Keith Newton
Then all you would need to do is plunge a parting tool through on your lines. It will turn like butter.

But another suggestion, may be to switch to PVC. You can probably find a scrap or fitting that works.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081