Messages Archive

Subject:
Another refinishing question

Keith Newton
The desk I'm refinishing has a console with tight cubby-holes for envelopes and in-out files that are too tight to use even a brush in, and if I tried to spray, I would end up getting more blow-back than what would end up in the holes.

Can the shellac which was suggested in an earlier post be thinned and wiped like a wipe on poly, or should I just go with the wipe on poly in there? The problem with that, is that some of this is open to the front, so breaking off from poly to sprayed with SWP pre-cat for the final coats becomes difficult.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081