Messages Archive

Subject:
Bow corrected.

JL
Jointed the edges again.
Put one bow up and clamped the ends down on my table saw (with a sheet of plastic over the table saw). Put the other bow side down.
Glued up the joint and worked from the center outward.
I was able to get the center lined up w/ a lot of hand pressure.
Worked out towards the ends.

I have a straight slab!! Without a twist or bow!!

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081