Messages Archive

Subject:
Re: Hole in air tank question
Response To:
Hole in air tank question ()

Keith Newton
For a temporary repair on Rolair twin tank that developed a tiny hole, I drilled it out a little larger to get a clean round hole that I inverted a toothpick into and cut very close. I then Slowly soaked that with thin / fast cyanoacrylate. It held fine until I replaced the tanks.
I tried the screw route without success on another one long before that.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081