Messages Archive

Subject:
Re: Delta jointer gib screw
Response To:
Delta jointer gib screw ()

Rick W
If I remember correctly, the gib screw is just a 1/4-28 setscrew with a cone point. That should be available from a good hardware store, or there are many online sources.The lock nut is a thin 1/4-28 nut, but a standard 1/4-28 nut will work.
Rick W

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081