Messages Archive

Subject:
Jointer question

Dan Bundy
Recently did some clean-up & tune-up of my Ridgid 6-inch jointer. Used it for the first time to face joint and edge joint. The face joint was a very rough ride though the surface looked smooth -- no washboard or snipe. Edge joint ride was smoother, also with a decent finish and no snipe. My thoughts are that one of the blades is higher than the other two. Am I on the right track? Thanks for your input.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081