Messages Archive

Subject:
File question

Bill Tindall, E.Tn.
How are files measured? Is a 10" file 10" of cutting length or 10" tang to tip?

What is the name of the cut where there are single grooves going diagonally?

Messages In This Thread

File question
Sometimes referred to as a mill file *NM*
Re: File question
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081