Messages Archive

Subject:
"undersized" Plywood bits?

JL
How many of y'all have undersized plywood bits?
I have always cut dados for plywood with my dado blade and my table saw.
I have a project which involves cutting dados and rabbets in several long pieces of somewhat wide plywood.
Not something I would care to do on my table saw.

Therefore I can cut the dados w/ a 3/4" router bit and have a little "slop" - or I can buy an undersized plywood bit (or set).

Thoughts?

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081