Messages Archive

Subject:
Working HDPE

Mark Mandell - Gone Round In New Jersey
I need to put a 90 deg bend in a piece of 1/4" HDPE. Anyone here do this outside of the commercial shop? I have a 1K heat gun but can't seem to get the sheet hot enough without actually melting the surface.

TIA

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081