Messages Archive

Subject:
Router bit question

Barry Irby
I need to cut a "dart" on a leg. Last time I did it I made the table leg an octagon and then glued the corners back on with the dart cut at the top of each piece. Now I am doing the chairs and the scale is much smaller,

I need a router bit that cuts at a 45* and has a flat tip. There is a common Vee groove bit, but it comes to a point. Is there a similar bit that has a flat tip?

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081