Turning

Subject:
Re: Heat problem?
Response To:
Re: Heat problem? ()

Pete in Holland MI
Bill - - Generally......bearings by themselves run with little heat. In a situation where there are 2 bearings, and either because of design, or installation, the pre-load can be too much. Does your spindle turn freely without the belt in place? If not, I suspect excessive pre-load and should be investigated.

Pete

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081