Turning

Subject:
Re: Powermatic 2020 question

Clifton C
I'm with the loose set screw crowd because mine is... :)
Not sure what manufacturer, but I have found two set screws in the same hole, one to hold the pulley to the shaft and the other, as far as I can tell, as a jamb set screw, if that makes sense. I've seen this on more than one occasion but couldn't tell if it came from the factory that way.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081