Turning

Subject:
Re: 2 Morse Taper Collets - PHOTO *PIC*

John K Jordan
One photo didn't display in my other reply. Here's the photo and a repeat of the text:

I made two sizes of drawbars, the smaller 1/4" is good for fastening long unsupported thin spindles by means of a hole drilled in the end of the blank. This one from walnut is over 24" long with a short #2 morse taper on one end to fit the headstock, the spindle turned with no steady rest.

JKJ

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081