Turning

Subject:
Re: Curtain around lathe
Response To:
Curtain around lathe ()

Roger
I cut slots with angle grinder in 2 1/2" pvc pipe mounted pipe with screws thru slots with 2, 45 degree ells @ corners.Turned wooden balls an screwed cup hooks into them, slid balls into the end of the pvc, hung curtain on cup hooks. Made my curtain from 6 mil plastic with self installed grommets.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081