Turning

Subject:
Chuck Adapters

Peter Toch
I have an older version of the original ONEWAY chuck (uses levers to tighten/loosen jaws) that has a 1-1/2" x 8tpi threaded hole (pre-Taperlock version) in the chuck body to accept a threaded inset to adapt it to various size lathe spindles. Has anyone tried either the Pen State LABAR418 (1-1/2" x 8tpi to 1" x 8tpi) adapter or the LABAR4114 (1-1/2" x 8tpi to 1-1/4" x 8tpi) adapter in the above ONEWAY chuck? If yes, did they fit and perform properly?

Thanks, Peter Toch

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081