Turning

Subject:
Re: How to cut this
Response To:
How to cut this *PIC* ()

AZ in Colorado Springs
How about a sort of offset turning? Trim the bottom, then make a jig that mimics a lathe. Chuck the base end in an offset manner. While a helper rotates the work piece you hold a pencil up and get the marks you need. Can make the cuts using a hand saw the same way.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081