Turning

Subject:
Re: PM 2020
Response To:
PM 2020 ()

Tom Borener
I have the 2020 and I am quite happy with it. I got it as a companion to my 3520A, but didn't need 2 big lathes. In my case, it was a compatibility issue - everything fits either lathe, and for the most part they operate the same. The only thing I have notices is that it vibrates more readily with a slight out of balance piece, than the larger beast

Messages In This Thread

PM 2020
Re: PM 2020
Re: PM 2020
Re: PM 2020
Re: PM 2020
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081