Turning

Subject:
Re: Remote switch
Response To:
Remote switch ()

Bill Howatt
I have a General 26020 VFD lathe and made a remote switch speed control for it quite a while ago. I don't know about the Oneway switch but I'll caution you that (at least on my 26020) the ON/OFF pushbuttons on the pedestal have the 240VAC line voltage connected to them - not a low control voltage. These switches actuate a relay in lathe that switches the control voltage from the VFD on and off.

I elected not to extend the wires to the switches to my remote box because of the voltage so I made some mods.

Bill

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081