Turning

Subject:
Re: Likely solution!
Response To:
Re: Likely solution! ()

mark paulley
Everyone thanks for the help, internet was down and i could not respond till now.
I was cutting out bread saws and then moved to cutting some square 2" blocks for bird houses when I started hearing this grinding noise. Stopped and notice blade on back of wheel, re-positioned and turned by hand and the blade continues to move to the back of the wheel. I will clean the rubbers on the wheels and start trying to figure this out. Good news is I had all of my bread saws cut and approx 20 bird house squares cut so I can at least build a little inventory before my show on Thursday.
I am not very mechanical minded but will take it slow and work through each suggestion till fixed
Again thanks to all of you machine gurus!!!!!!!!!!!

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081