Turning

Subject:
Re: Hunter question
Response To:
Hunter question ()

Julian
I recently used a Hunter cutter on a hollow form. I purchased the cutter separately from AZ Carbide and used it on my homemade hollowing rig. I used a 10mm cutter and found it to cut fairly smooth on end grain but a little rougher on the side grain. It takes some practice to get the cutter angled correctly for a smooth cut. But I will definitely use the Hunter cutter again and even purchased a 12mm cutter which I think is the #5.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081