Turning

Subject:
Re: Piercing issues
Response To:
Piercing issues ()

Brian Roberts
Any collet loosening issues can be traced to mating surfaces not mating truly to each other.

Shaft must be fully inserted (at least to the full depth of the straight portion of the gripping area) in a collet that is in good condition.

On one occasion I found the inner collet part to be actually for a different collet system....the angled mating areas were not the same angle.

At least I have never found the cause to be anything else.....YMMV

Messages In This Thread

Piercing issues
Re: Piercing issues
Re: Piercing issues
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081