Turning

Subject:
Re: Lidding a hollow form

Ray Carson - Lawrenceville, NJ
That's exactly what I'm talking about. I thought about a waste block but was looking for alternatives. That being said, the glue joint becomes an issue though, correct? If I understand you correctly, that's what you part off? If so, how do you finish that cut? Hand sand and finish?

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081