Turning

Subject:
Re: Goblets
Response To:
Re: Goblets ()

lyle Jamieson
OK I see it clearly now. Go back and revisit the Kobra system option. It will take all the work and fear of catches. If you are getting catches with the Kobra look at my setup instructions and pretend you got it from me. My system with the Hunter carbide cutter in slicing mode (not scraping) will leave it with no sanding needed. The Kobra should be able to do the same. If you have the laser it will save you a lot of time, also and get your wall thickness uniform. A captured bar will be able to get into the same small sizes, like a goblet, as you can reach with hand held tools.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081