Turning

Subject:
Here's a stupid answer
Response To:
Re: Stupid Question ()

Ron Bauer
Why not use a small trim router with a 1/8" bit to cut the rings. A simple table and guide can be set up to do this and there is perfect control at very stage. No running of the lathe is involved. Since it sounds like you will be making more of these it might pay to make a set up. R.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081