Turning

Subject:
Re: Question......
Response To:
Re: Question...... ()

John K Jordan
I'm not familiar with that lathe but if there is no device built in I might make a stop bar for the handwheel - if solid, drill a hole and hold with a pin on a bar (or a bent bar) and lever against the outboard end of the spindle.

JKJ

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081