Turning

Subject:
Re: walnut tray *PIC*
Response To:
Re: walnut tray ()

Ray Mtn. Home Ar.
The side view you asked for. I edge glued a couple of pieces of 3/4 X 6 boards, glue a block on the back and chuck it up. I turn it in the lathe and then move the tray and chuck to the rose engine and cut the pattern.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081