Turning

Subject:
Re: brass rod?
Response To:
Re: brass rod? ()

mikeee12345
You could add a washer onto the surface of the clamping nut to fill the void for the smaller tool.
This would still allow the tool to be clamped level in the saddle of the jig.
You could magnetize the washer so it would hold on to the clamping nut and not fall of.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081