Turning

Subject:
Re: Selling a lathe
Response To:
Re: Selling a lathe ()

john lucas
A good machinist can reduce the tool rest shaft quite easily on a mill, if you have a friend who is a machinist. Would cost as much as the rest to pay someone to do it. I downsized an older S shaped rest with a 1" shaft down to 5/8" to fit my mini lathe.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081