Turning

Subject:
Re: looking for recommendations on lathes

George Balock
Dick has a good point here. If you are turning 22" bowls, you are going to want as much HP as you can get. When I had my Nova 3000, I was coring 14" bowls and the 1HP motor could hardly do it. On my current 3 HP lathe, not even close to an issue.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081