Turning

Subject:
good point
Response To:
Re: call me crazy... ()

GaryG in MD
I was just messing around, and this was my first try to match the existing hand sharpened shape, so it was a bit of an approximation. For the future and second sharpenings, some bits have flat sides for the set screw, but some have been ground round. Your point is well taken about the next time for the round ones. They could have a small flat ground on them. Also, for complete repeatability, a small flat would have to be ground on the top of the bar where it clamps in the VariGrind. That's doable too. Otherwise, it won't be 'perfect'; but the Mark I eyeball should do a pretty good job. ...GG

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081