Trivia

Subject:
VERY close

Alex Y
Nice job.

I'm not sure what your method was, but I guess from the diagram that you used a CAD or other graphic program to create a circle through the 3 points that are determined, then measured the circle. Your result is only off a very small amount, accurate to 2 decimal places. But what I am looking for is the EXACT answer, not an arbitrarily close approximation.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081