Messages

Subject:
Re: OT: ID This Lattice Material?

Keith L Newton
Maybe HDPE or 3Form. But if you want to get that look a lot cheaper, I would go with MDF or HDF if you can find it. I think if I were going to make that, without a CNC router, I would start by jigsawing a template from 1/4" MDF, then using a bearing over router bit or template in the base to do the actual cutting. Then painting the final sheet black would give a pretty good likeness for that look.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081