Messages

Subject:
Re: 1/2" diameter
Response To:
1/2" diameter ()

Walt
It sure seems like a bushing is going to be it for a bit that small. You'd just have to figure out the offset. Something I'd be inclined to try would be to create a guide with a slot near the center, the slot accomodating the guide bushing snugly. Center the slot over the desired groove and clamp.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081