Messages

Subject:
Round nose router bit (or veining bit)?

JL
Freud has some round nose router bits in the 1/8" to 3/16" diameter - that's about where I would like to be for the grooves in a project.

As I will be following a template, I would prefer to have a bearing on the bit. I suppose I could just make a slotted template at 1/4" wide and rely on the shaft to act as a pseudo bearing - but that does mean I have to make a slotted template.

Thoughts?

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081