Messages

Subject:
Bosch routers

Johanna Johanson
I want another router. I currently have a Bosch EVSPK and a Porter Cable 690. I have a spiral upcut 1/2 inch in the Bosch and a dovetail bit in the Porter Cable. Those are being used to cut the dadoes for vertical dividers in a couple of dressers. It would be very convenient to have a third router set up with a dovetail bit in the router table to rout the edges of the dividers.

So here's the question: if I buy a Bosch EVS, is it exactly the same machine as the EVSPK - just without a plunge base? Will it fit in the table undermount that I have for the EVSPK?

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081