Messages

Subject:
Got a saw mill near?

Mark Mandell - Gone Round In New Jersey
See if they have a debarker and will run your pieces for you. If you piece is too small (short) your option may be to mount it on a lathe and use a roughing gouge. I've had a Lancelot carver (chain saw chain segment held on a disc) for my 4" angle grinder for years that uses the cutters oriented on the outer edge; I wouldn't recommend it for this job; dangerous.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081